Many Tribology Group publications are Open Access thanks to funding from the EPSRC.
@article{Bahshwan:2022:10.1016/j.wear.2021.204193,
author = {Bahshwan, M and Gee, M and Nunn, J and Myant, CW and Reddyhoff, T},
doi = {10.1016/j.wear.2021.204193},
journal = {Wear},
pages = {1--12},
title = {In situ observation of anisotropic tribological contact evolution in 316L steel formed by selective laser melting},
url = {http://dx.doi.org/10.1016/j.wear.2021.204193},
volume = {490-491},
year = {2022}
}
TY - JOUR
AB - A consensus on the tribological performance of components by additive-versus conventional manufacturing has not been achieved; mainly because the tribological test set-ups thus far were not suited for investigating the underlying microstructure's influence on the tribological properties. As a result, utilization of additive manufacturing techniques, such as selective laser melting (SLM), for tribological applications remains questionable. Here, we investigate the anisotropic tribological response of SLM 316L stainless steel via in situ SEM reciprocating micro-scratch testing to highlight the microstructure's role. As-built 316L SLM specimens were compared against annealed wire-drawn 316L. We found that: (i) microgeometric conformity was the main driver for achieving steady-state friction, (ii) the anisotropic friction of the additively manufactured components is limited to the break-in and is caused by the lack of conformity, (iii) the cohesive bonds, whose strength is proportional to frictional forces, are stronger in the additively manufactured specimens likely due to the dislocation-dense, cellular structures, (iv) low Taylor-factor grains with large dimension stimulate microcutting in the form of long, thin sheets with serrated edges. These findings uncover some microstructurally driven tribological complexities when comparing additive to conventional manufacturing.
AU - Bahshwan,M
AU - Gee,M
AU - Nunn,J
AU - Myant,CW
AU - Reddyhoff,T
DO - 10.1016/j.wear.2021.204193
EP - 12
PY - 2022///
SN - 0043-1648
SP - 1
TI - In situ observation of anisotropic tribological contact evolution in 316L steel formed by selective laser melting
T2 - Wear
UR - http://dx.doi.org/10.1016/j.wear.2021.204193
UR - https://www.sciencedirect.com/science/article/abs/pii/S0043164821005767?via%3Dihub
UR - http://hdl.handle.net/10044/1/92681
VL - 490-491
ER -